TACER

23/06/2026

finished with the air seeder for the season?
Rainy days are perfect to knock your points off and bring them in for a touch up.
These "Equaliser direct drills" came in with varying were, with a strip down the each side to combat the point washing away behind the tile and a run on the very bottom to stop vertical where, these ones are good to go again.

22/06/2026

Recently completed set of 7" scarifiers completed for a return customer.
Get in contact to find out how different patterns can help with different jobs.

23/03/2026

Full modification to these “Strip Tiller” tynes, customer wanted a solution to the original point that wasn’t lasting very well. The original point had a tungsten tile in the leading edge and sat very flat wearing the heel off the shank and around the back tile, the tile would just snap off and the point was gone in no time.

23/03/2026

A great example of how you can get the most out of your direct drill points.
These points came in at brand new for the short run of TACER you can see to stop the wash behind the tile, roughly 8 thousand acres later they come back for another touch up.

just because they're worn doesn't mean we can't get more out of them.

09/02/2026

Tungsten tiles are a great thing, but not in every application.
Stoney/rocky country and tiles don’t mix. As shown below, it starts with it chipping the corner and ends with notjibg Left.

Luckily there’s other Hardfacing applications available.

28/01/2026

Set of points and adapters for a local “623 CAT” scraper.

Get in touch for all your earthmoving wear parts

12/01/2026

11/01/2026

over 24 years ago Humps went to work on hard facing Murray River Councils "road reclaimer" (road mixer). The drum in these things spins at a rate of knots with some very high ware areas.
over the years TACER has seen a number of these machines roll in and out, with this flash new one being completed late last year.

The latest machine came in with just 180 hours, and check out the ware already.